Skip to content

How a Cadence Sensor Works

Checked November 20, 2026

A cadence sensor notices that the cranks are turning. That's the whole job. It doesn't know how hard you push.

What cadence means

Cadence is another word for pedaling rate. It's the motion of the cranks rotating as the rider pedals.1 Cranks are the arms that hold the pedals.

The parts

The common design uses two pieces. A magnet ring sits on the crank arm or around the bottom bracket area, which is where the cranks connect to the frame. A small sensor sits just beside it on the frame.2

As you pedal, the magnets pass the sensor. Each time one does, the sensor sends a signal to the motor controller.2

How a cadence sensor reads pedalingCranks turn the magnet ringMagnets pass the sensorSensor sends a signalController sets assist level
Magnets passing the sensor become a signal.

Some bikes fit the sensor on the bottom bracket of the frame, and the sensor's purpose is to tell the controller that the pedals are being actuated.1 The controller then sends the motor an amount of assist based on your chosen assist level.1

How the signal becomes assist

The sensor only reports motion. So the controller has a fixed amount of help for each level you pick. On most e-bikes with this type of sensor, the assist is more of a binary system, with the motor either on or off.3

Think of it as a switch with a few preset strengths. Pedal harder or softer and the preset stays about the same.

Why there can be a short wait

Electrek says there is usually some lag between the pedaling starting and the motor kicking in. It puts the cause down to the sensor waiting to see how many magnets pass by in a given time period.3 The sensor needs a few passes before it's sure you're really pedaling.

The same article describes the lag as 1 to 2 seconds in some cases, which is noticeable on a start in a high gear or on a hill.3

You also have to move the pedals a little before the motor engages.4 That's why many bikes with this sensor also have a throttle, so the rider can get moving first.4 The page on why a motor starts late or runs on goes further into this.

What the ride feels like

InsideEVs says the simple design can sometimes result in jerky starts.1 How noticeable it is depends on the assist level and the bike's tuning.

For a side-by-side view, see torque sensor vs cadence sensor.

The gap matters

The ring and sensor must sit close together. Upway puts the gap at typically around 1 to 3 mm, but the exact figure depends on your bike.2 Your manual gives the right figure for your model, and it's the source to follow for any adjustment.

If the ring or sensor gets knocked, the signal can weaken or stop. Upway lists a crash, a hard landing and car-rack transport as ways that can happen.2 A bike shop can check the alignment if the assist seems wrong.

Reference list

  1. E-Bike Tech: The Difference Between Cadence Sensors And Torque Sensors, InsideEVs
  2. How to Fix an E-Bike Pedal Assist Sensor, Upway
  3. Torque sensors vs. cadence sensors for electric bikes, Electrek
  4. What is the Difference Between Sensor Types on an Electric Bike?, EVELO